Hid EDGE Reader Installation Guide Manuel d'utilisateur télécharger pdf

Installation Guide English

P/N 82000-902-ENEN Rev B.1

EdgeReader

and EdgePlus

CAUTION: The product is sensitive to Electrostatic Discharges (ESD). Observe precautions while handling the circuit board

assembly by using proper grounding straps and handling precautions at all

times.

1 Preparation (For Indoor Use Only)

Install electrical box.

For new installations: 4” square electrical box (minimum 1 ½” deep) with a

single-gang plaster ring, or equivalent.

Note: To prevent tampering, conceal plaster ring mounting screws with

plasterboard or use tamper resistant screws.

For surface-mount installations: Wiremold

V5744S or BW35,

or equivalent.

Remove metal back plate from unit and mount to electrical box, as shown.

2 Wiring

Ethernet

300 feet (100 m) Category 5 cable ALPHA 9504C / 9405F

Wiegand

500 feet (150 m) 9-conductor, stranded, overall shield, 22 AWG ALPHA 1299C

Input Circuits

500 feet (150 m) 2-conductor, shielded, 22 AWG, 18 AWG ALPHA 1292C / 2421C

Specifications

Output Circuits

500 feet (150 m) 2-conductor, shielded, 22 AWG, 18 AWG ALPHA 1172C / 1897C

RS-232

50 feet (15 m) 9-conductor, stranded, 22 AWG ALPHA 1299C / 58119

1 2

Installation Guide English P/N 82000-902-ENEN Rev B.1 EdgeReader® and EdgePlus® CAUTION: The product is sensitive to Electrostatic

3 Mount Hinge the Edge in place and secure with a screw. 4 Contact Contact Edge through one of the following methods: Direct Connect If Edge will

Pas de commentaire

Hid EDGE Reader Installation Guide Manuel d'utilisateur