Hid EDGE EVO EH400 Hi-O Controller Installation Guide Manuel d'utilisateur télécharger pdf

EDGE EVO is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture,

IP-centric environments, EDGE EVO provides fully distributed intelligence and decision making right to the door, leveraging the IT

infrastructure to the maximum extent possible. Wire the EDGE EVO device to Hi-O interface modules providing connectivity to electronic

door components and access control readers.

Hi-O involves devices with built-in intelligence and a CANbus that links all the devices together. Password protect or encrypt Hi-O CANbus

data trafc. Each Hi-O device (such as the push plate, electric strike, card reader and door operator) is connected to the CANbus by a

single, four-wire cable. Two of the wires supply power and the other two are used for data communication.

Specications

CONDITIONS VOLTAGE DC (VDC)

CURRENT

(Amp)

OPERATING

TEMPERTURE

CABLE LENGTH

UL REF

NUMBER

Input

DC Input (NSC)

+12 VDC 0.14 Amp

32° - 122°F

(0° - 50° C)

Hi-O CAN Bus Total Length 100 ft (30 m) -

22 AWG ● 0.65mm ● 0.33mm

Maximum between drops 30 ft (10 m)

22 AWG ● 0.65mm ● 0.33mm

RJ45 = 328 ft (100 m) - Category 5 K

E400CxNN

+24 VDC 0.08 Amp

PoE (+48VDC NOM) 0.05 Amp

DC Input (MAX)

+12 VDC 1.5 Amp

+24 VDC 1.5 Amp

PoE (+48 VDC NOM) 0.3 Amp

Ouput

CAN DC

Output

(MAX)

AUX 12 / 24 VDC Input +10.8 to +24 VDC 1.2 Amp*

PoE Input + 24 VDC (NOM) 0.4 Amp*

NSC = Normal Standby Condition

* Combined output ratings are not to exceed 1.2 Amps (AUX Input) or 0.4 Amps (PoE Input). X = K for Black

G for Gray

EDGE EVO

Hi-O Networked Controller

EH400

InstallatIon GuIde

82000-920, Rev C.0

October 2011

15370 Barranca Parkway

Irvine, CA 92618-2215

USA

1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - EDGE EVO

EDGE EVO is the next evolution in access control hardware solutions. A true IP solution that meets the demands of open architecture, IP-centric enviro

Page 2 - Power Analysis

Page 3 - Device Ports Conditions I out

Page 4 - INSTALLATION GUIDE4

RegulatoryULConnect only to a Listed Access Control / Burglary power-limited power supply, or Listed Access Control / Burglary PoE (Power-over-Etherne

Page 5 - Step 4 - Select Power Scheme

Page 6 - Mounting

Page 7 - Install to Backplate

Page 8 - 5.1 Direct Connect

Page 9 - Power & Testing

Page 10 - Glossary

Page 11 - INSTALLATION GUIDE 11

Page 12 - HID Global